This should clear the flag on the disk, please try to initialize the SSD again. This will list all the details of the selected disk.Ĭheck if the ReadOnly flag is set to Yes. Where X is the number of your Intel® SSD, then do the following Note down the number of your new SSD, then do the following ![]() This will list all the disks in your system. ![]() Run the following commands on the diskpart prompt Check this link also for further information: (v=ws.10).aspx DiskPart Command-Line Options the example below shows the command being used for the disk but you can use similar command for the partition. Based on your description you can use the command below. If I set a file as 'Write Protected', will I be able to delete afterwards This question has probably been asked before but Im new to Linux so I dont know what to look for. ![]() Please, bear in mind that you can do this procedure for the the partition, volume and disk. In this case, it may be that the Disk is set to "Read Only" and this is preventing you from formatting the drive.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |